To determine the correct load, it is necessary to specify the position of the drifted snow according to nodes of the roof surface.
This way, you can quickly create two load cases: "Snow with Drifted Snow" and "Snow Without Drifted Snow."
To determine the correct load, it is necessary to specify the position of the drifted snow according to nodes of the roof surface.
This way, you can quickly create two load cases: "Snow with Drifted Snow" and "Snow Without Drifted Snow."
Mr. Baumgärtel provides technical support for Dlubal Software customers.
There are load generators available for beam structures, creating snow loads according to ASCE/SEI 7-10. The load cases are generated depending on the roof shape. Another generator creates coating loads (ice). You can save recurring load combinations as templates.
The results of solid stresses can be displayed as colored 3D points in the finite elements.
Do you want your structures to remain upright even in wind and snow? Then rely on the load wizards for plate and frame structures. You can now generate wind loads according to EN 1991‑1‑4 and snow loads according to EN 1991‑1‑3 (as well as other international standards). The load cases are generated depending on the roof shape.
Wind loads are also not a problem in your design. You can automatically generate wind loads as member loads or area loads (RFEM) on the following structural components:
The following standards are available to you: