It is possible to select whether it is a sharp-edged eaves area, an eaves area with attic, a rounded eaves area, or a beveled eaves area. Then, the corresponding loads are applied according to EN 1991‑1‑4 Table 7.2.
It is possible to select whether it is a sharp-edged eaves area, an eaves area with attic, a rounded eaves area, or a beveled eaves area. Then, the corresponding loads are applied according to EN 1991‑1‑4 Table 7.2.
Mr. Baumgärtel provides technical support for Dlubal Software customers.
There are load generators available for beam structures, creating snow loads according to ASCE/SEI 7-10. The load cases are generated depending on the roof shape. Another generator creates coating loads (ice). You can save recurring load combinations as templates.
The results of solid stresses can be displayed as colored 3D points in the finite elements.
Do you want your structures to remain upright even in wind and snow? Then rely on the load wizards for plate and frame structures. You can now generate wind loads according to EN 1991‑1‑4 and snow loads according to EN 1991‑1‑3 (as well as other international standards). The load cases are generated depending on the roof shape.
Wind loads are also not a problem in your design. You can automatically generate wind loads as member loads or area loads (RFEM) on the following structural components:
The following standards are available to you: