Elements

Elements are required for calculation using the 'Thin-Walled Analysis' analysis method and for the calculation of the effective cross-section.

The position of the individual elements is determined by means of their start and end points. For complex types of elements, additional intermediate points are required.

Elements can be connected only at their start and end points. When elements cross each other without sharing a point, no connection exists.

Elements, with the exception of null elements, must always lie in a part. You have to create this part in advance when entering an element using the dialog box. In contrast, when entering elements graphically, the part is created automatically. A part is only considered in the calculation using the design method 'Thin-Walled Analysis' and for the calculation of the effective cross-section if at least one element lies in this part.

The element number is assigned automatically, but it can be changed. The order is irrelevant for the numbering. It does not have to be continuous, either; gaps in the numbering are allowed.

Base

The Main tab manages the basic element parameters.

Element Type

Various element types are available for selection in the list.

single line

The 'New Element' dialog box is shown in the Dialog Box 'New Element' .

A single line is defined by a start point and an end point. It represents a direct connection between both points.

When entering graphically, use the button , you can select existing points, grid points, or snap objects as definition points. However, you can also set the points freely in the work plane.

Arch

An arc is defined by three points. In the 'Arc' tab, you can enter the start point P₁, the end point P₂, and the control point P₃, select them graphically or create a new one. The graphic illustrates the order of the points.

From the three points, RSECTION determines the 'arc parameters': the rise h, the radius r, the opening angle α, and the arc center. If you change a parameter, the point coordinates will be adjusted accordingly. When changing the opening angle, you can use the list to define which of the three definition points should be moved.

Click the button to deactivate the arc graphically, you can select the points or define new points directly in the work window.

Circle

A circle is defined by its center and the radius. In the 'Circle' tab, you can enter or graphically define the coordinates of the circle center and specify the circle radius.

If you click the button you can define the center point and radius in the work window by clicking the corresponding points.

Ellipse

To define an ellipse, three points are required. To define the principal axis of the ellipse, you can enter the two points P₁ and P₂, select them graphically, or define new points in the 'Ellipse' tab. The control point P₃ describes the length of the minor axis.

Parabola

This element type allows you to create a conic section curve. Define the two end points of the parabola and the control point in the 'Parabola' dialog tab. Based on this information, RSECTION determines the parabola parameters and the focus.

Click the button to define the parabola you can define the points in the work window by clicking them, or you can define new ones.

NURBS

NURBS elements (non-uniform rational B-splines) can be used to model any curve elements.

Additionally, NURBS elements can be selected with the button graphically by defining the control points one by one with a mouse click.

Material

When entering an element graphically, you can select a material in the list of already created materials, edit it, or define a new one. When entering an element via the dialog box, the material is imported from the part.

Thickness

The real thickness of the element must be defined in this text box.

Effective thickness for shear transfer

The effective thickness for shear transfer corresponds to the thickness of the element by default. If you activate the check box, you can set a thickness for the shear transfer that differs from the actual thickness.

Information | Analytical & Mesh

This dialog section provides an overview of important properties of the element, such as area and length.